> Although 2 micron may be the 'advance mechanism division' it
doesn't
> necessarily mean that's the minimum slice cut.
Thanks David,
The advance mechanism is 20 microns not 2, that is my complaint about
the description.
I was making what I thought was 10 micron slices, that is 5 clicks
per slice, thinking, "this is easy".
But I always had trouble with air creeping in to the edge of the
slides. It was then, using a feeler guage I noticed the gap between
coverglass and slide was a lot bigger than 10 microns. It was in fact
100 microns.
It's much harder to produce a section after 1 click, ie 20 microns,
but then much easier to produce a good slide.
I don't have a problem with Brunnel, I think they just copied the
item description from the manufacturer. besides I have had it a
couple of months - took me that long to realise.
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch format to Traditional
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe
__,_._,___
Tidak ada komentar:
Posting Komentar